Node:set value, Next:ifset ifclear, Up:set clear value
@set and @valueYou use the @set command to specify a value for a flag, which is
later expanded by the @value command.
A flag is an identifier. In general, it is best to use only
letters and numerals in a flag name, not - or _--they
will work in some contexts, but not all, due to limitations in TeX.
The value is the remainder of the input line, and can contain anything.
Write the @set command like this:
@set foo This is a string.
This sets the value of the flag foo to "This is a string.".
The Texinfo formatters then replace an @value{flag}
command with the string to which flag is set. Thus, when
foo is set as shown above, the Texinfo formatters convert this:
@value{foo}
to this:
This is a string.
You can write an @value command within a paragraph; but you
must write an @set command on a line of its own.
If you write the @set command like this:
@set foo
without specifying a string, the value of foo is the empty string.
If you clear a previously set flag with @clear flag, a
subsequent @value{flag} command will report an error.
For example, if you set foo as follows:
@set how-much very, very, very
then the formatters transform
It is a @value{how-much} wet day.
into
It is a very, very, very wet day.
If you write
@clear how-much
then the formatters transform
It is a @value{how-much} wet day.
into
It is a {No value for "how-much"} wet day.